Installation - Franklin Electric PUMPTEC-PLUS Guía De Instalación Y Funcionamiento

Installation

1. Remove Cover
Remove the Pumptec-Plus cover by removing the cover screw and sliding the cover up. Place cover
in a safe location.
2. Set the Timer Switch
Set the automatic timer switch to the desired reset time. This will determine the time after an
underload trip condition (dry well condition) has occurred until the Pumptec-Plus will try to restart
the motor.
Notch indicates
timer selection
PUMPTEC-PLUS Pump Protection System
FRONT COVER SCREW
Timer Switch Settings
0) Manual Reset
1) 1 Minute
2) 2 Minutes
3) 4 Minutes
4) 8 Minutes
5) 16 Minutes
6) 32 Minutes
7) 1 Hour 4 Minutes
8) 2 Hours 8 Minutes
9) 4 Hours 16 Minutes
5