Franklin Electric PUMPTEC-PLUS Guía De Instalación Y Funcionamiento página 6

PUMPTEC-PLUS Pump Protection System
3. Mount the Unit
Mount the Pumptec-Plus unit in a location convenient for wiring. Avoid direct sunlight, rain or
snow.
WARNING
4. Connect Power and Motor
Check to make sure the 230 Volt power has been disconnected. Connect Pumptec-Plus unit to
the pump motor and the 230 Volt AC line according to one of the two- or three-wire installation
drawings below. Pumptec-Plus may be wired into the circuit before or after the pressure switch,
float switch or other system control switch.
GND
GND
6
DISCONNECT POWER AT THE MAIN PANEL before installing,
wiring or servicing the Pumptec-Plus unit. Serious or fatal shock
may occur if power is not disconnected.
SCREW
2-WIRE INSTALLATION
L2 L1
GND
FUSED
DISCONNECT
OR
CIRCUIT
BREAKER
GND
L2 L1
PRESSURE
SWITCH
OR OTHER
CONTROL
L2 L1
L1
L2
M1
M2
GND
PUMP &
MOTOR