Cleaning The Lock; Replacing The Batteries - Allegion Schlage Sense Guia Del Usuario

Cleaning the Lock

In order to properly clean the touchscreen from build-up of dirt, oils, or other contaminants
you should use a mild dish soap with warm water and follow the general rules below:
• Do rinse the touchscreen with warm water prior to cleaning process.
• Do follow the application of soap with a damp, lukewarm cloth.
• Don't use abrasives, high alkaline cleaners, or gasoline.
• Don't leave cleaners on touchscreen for long periods, wash immediately.
• Don't apply cleaners in direct sunlight or at elevated temperatures.
• Don't use scrapers, squeegees or razors.
The bolt itself can be cleaned using a mild dish soap and warm water. This can help
improve decreased performance.

Replacing the Batteries

»
Replace the batteries in your lock at the same time each year that you test and replace
the batteries in your smoke alarms. This will help ensure continued reliable operation.
»
Use four high-quality alkaline AA batteries for replacement.
1. Remove the inside cover.
Lithium Batteries?
Lithium batteries may have a longer life, but when they begin to fail, they fail
quickly. We don't recommend them because they don't give you a lot of time
to change your batteries before the lock is completely dead.
6 6
WARNING
ELECTROSTATIC DISCHARGE
DO NOT TOUCH the circuit board!
You may damage the lock.
2. Unsnap the battery
connector, remove
the battery tray and
replace the batteries.
3. Replace the battery tray
with the batteries facing
the door. Snap the battery
connector to the tray and
replace the cover.