Manual Programming Guide; Programming Descriptions - Allegion Schlage Sense Guia Del Usuario

Manual Programming Guide

Use the app to easily program your lock!
NOTE: Existing access codes will be deleted when you configure your
lock with the app!
Schlage recommends using the Schlage Sense mobile app to program your lock. If you
don't have the Schlage Sense app, you can use the manual programming instructions
below.
Manual programming functions are NOT available after
pairing using the mobile app! You must perform a Factory
Default Reset to program your lock manually.
Outside Schlage Button
• The first button
you will press in the
programming process.
• Can also be pressed
to exit programming
immediately.
Green Check Mark
• Blinks when a number
key is pressed and when
a function is complete.

Programming Descriptions

Add Access Code
Delete Access Code
Change Programming
Code
Enable/Disable
Beeper
Delete ALL Access
Codes
Enable/Disable
1-Touch Locking
Change Access Code
Length
Enable/Disable Auto-
Lock
Temporarily
Disable
Auto-Lock
Restore
Auto-Lock
WARNING
Access codes unlock the deadbolt. Can be 4 - 8 digits long. All
codes must be the same length as the first code programmed
into the lock. See Changing Access Code Length below.
Removes one access code at a time.
The Programming Code is used to put the lock into
Programming Mode. It is 6 digits long.
The beeper can be turned off if desired. Beeps will still sound
during programming.
Removes ALL access codes from the lock.
When enabled: Press the Outside Schlage Button to lock the
deadbolt. (Default setting).
When disabled: Press the Outside Schlage Button and then
enter an access code to lock the deadbolt.
Access codes can be 4 - 8 digits in length. Default is 4 digits.
Changing the access code length will delete all existing access
codes!
When enabled, the lock will automatically relock 30 seconds
after unlocking. (Disabled by default).
Auto-Lock must already be enabled. While the deadbolt is
locked, press the Outside Schlage Button and then enter a 4-8
digit access code to unlock the deadbolt. Within 5 seconds,
manually lock and unlock the deadbolt using the thumbturn.
Lock the deadbolt using the thumbturn.
Red X
• If there is a problem
during programming,
you will see the red
error X.
Programming Indicator
• Blinks when
Programming Mode is
entered.
• Solid while a
programming function
is being performed.
7