Dometic SW 180 Instrucciones De Instalación Y Funcionamiento página 20

To adjust the size of the compartments, follow
these steps:
1. Remove the separation shelf.
2. The separation damper is now visible at
the back of the compartment. Detach it by
removing the two screws.
Separation damper
. Move the separation damper to its new
location. Fasten it properly using the two
screws removed earlier. (The rectangular
holes indicate where it is possible to place
the separation damper. Choose between 5
different positions.)
. Put the separation shelf in place.
5. Then, check the sliding shelves. These
shelves are equipped with self-adhesive
plastic sealing strips. In order for the wine
cellar to work satisfactory, verify that
these strips cover the holes at the back of
the compartment completely.
Sealing
strip
The installation is now complete and you
can start using the service wine cellar.
OPERATING INSTRUCTIONS
Ensure the sealing
strip covers the
hole completely!
USING THE SLATE SySTEM
Enclosed you will find a number of reusable mag-
netic strips. These can be attached to the front of
the shelves. Use the pen from the parts bag, a white
chalk or similar to enter suitable information about
your wines. You can write and rub out names as
often as you like.
- 20 -