Maintenance And Inspection - Hitachi P 20DA Manual De Instrucciones

MAINTENANCE AND INSPECTION

CAUTION: Pull out battery before doing any inspection or maintenance.
1. Inspecting the blades:
Continued use of dull or damaged blades will result in reduced cutting efficiency and may
cause overloading of the motor. Sharpen or replace the blades as often as necessary.
2. Handling
CAUTION:
The front base, rear base, and cutting depth control knob are precisely machined to
obtain specifically high precision. If these parts are roughly handled or subjected to
heavy mechanical impact, it may cause deteriorated precision and reduced cutting
performance. These parts must be handled with particular care.
3. Check the Mounting Screws
Loose mounting screws are dangerous. Regularly inspect them and make sure they are
tight.
CAUTION: Using this power tool with loosen, screws is extremely dangerous.
4. Check for Dust
Dust may be removed with a soft cloth or a cloth dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for they may damage the plastics.
5. Disposal of the exhausted battery
WARNING:
6. Storage
Storing in a place below 104°F (40°C) and out of the reach of children.
7. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be used,
all service and repairs must be performed by a HITACHI AUTHORIZED SERVICE CENTER,
ONLY.
Do not dispose of the exhausted battery. The battery must explode if
it is incinerated. The product that you have purchased contains a
rechargeable battery. The battery is recyclable. At the end of it's useful
life, under various state and local laws, it may be illegal to dispose of
this battery into the municipal waste stream. Check with your local
solid waste officials for details in your area for recycling options or
proper disposal.
English
23