Cleaning And Maintenance; Scope Of Delivery - HSM shredstar S5 Instrucciones De Servicio

6 Troubleshooting
Paper jam
You have fed in too much paper.
 The cutting unit runs in reverse for a few
seconds and pushes the paper back out
again.
If necessary, press the reverse button "R"
to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Bin full
 The cutting unit is switched off.
NOTICE
Empty the cut material container, immedi-
ately because if it is too full, malfunctions
can occur in the cutting system.
There are recessed handles in the housing
top to make it easier for you to lift the cutting
head.
Cutting unit runs continuously
- The light barrier in the paper feed is
blocked with paper. Press the paper
through with a thin strong piece of card-
board.
- The light barrier is soiled with paper dust.
Clean the sensor with air pressure, a dry
paintbrush or a cloth.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contact-
ing our customer service. If the motor was
overloaded, let the shredder cool down for
15 to 20 minutes before using it again.
08/2016

7 Cleaning and maintenance

WARNING
Dangerous mains voltage!
Improper handling of the machine can lead
to an electric shock.
Switch the shredder off before
relocating or cleaning it and
disconnect the mains plug.
Service work which requires the
housing covers to be removed
may only be carried out by HSM
Customer Service and service
technicians of our contractual
partners. See page 128 for our customer
service addresses.
Clean the document shredder only with
a soft cloth and a mild soap-water solu-
tion. However, no water must enter the
equipment.
8 Disposal / Recycling
Electrical and electronic old
devices contain a variety of valu-
able materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.

9 Scope of delivery

• Paper shredder in carton packing
• Operating instructions
HSM shredstar
english
11