GE CDT 725 Serie Manual Del Propietário página 7

GEAppliances.com
m
m
Start Dishwasher
Start
Open door to select the desired options. Press the Start button and close the door within 10 seconds to start the
cycle or begin the Delay Hours countdown. The wash cycle will begin shortly after closing the door. The display
will turn off if the door remains open for two minutes. To activate the display, close and open the door or press
any button.
Interrupt To interrupt or pause a dish cycle, slowly open the door. Opening the door will cause the wash cycle to
or Pause pause. The dishwasher will beep every minute to remind you to close the door. To restart or resume
the cycle, press Start, and close the door within 10 seconds.
Cancel To cancel a wash cycle, press and hold the Start button for 3 seconds and close door. The dishwasher will drain,
emit a beep sound, and the wash cycle light will turn OFF.
Cycle Indicator Lights and Sounds
Sanitized
or Displayed at end of the cycle when Wash Temp Sani or Sanitize Temp has been selected and dishwasher has
Cycle Sanitized
met requirements for sanitization. See Wash Temp Sani or Sanitize Temp, for complete description. Closing door
or pressing any button will turn off light.
Clean
or Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean.
Cycle Complete
Low Rinse Aid
Displayed when rinse agent is low or empty. See page 8 for Use a Rinse Agent. To turn indicator off, press the
(on some models) Pre-Soak or Steam button 7 times within 5 seconds. Repeat this process to turn the Low Rinse Aid indicator back
on.
Cycle Status
The indicator light on the door front will change color to indicate the wash status. During the wash cycle, the
(on some models) indicator light will be amber. When the wash cycle is complete, the light will change to green.
Sounds
The dishwasher will emit a sound to indicate cycle completion, button presses, and door ajar. To mute all sounds,
press the Heated Dry or Power Dry button 7 times within S seconds. Repeat this process to turn sounds back on.
Door Wake
Up Mode
(on some models)
To turn this option ON/OFF, press and hold the STARTand WASH TEMPbuttons for Sseconds. In the OFF mode,
the control display, control sounds, and interior lights (on some models) will not respond to the door opening/
closing. This mode can be used when observing certain religious holidays such as the Sabbath. To activate the
control and interior lights, press any button.