Specifications
Display: 3-3/4–digit OLED (4000 counts)
Jaw Opening: 35 mm (1.38")
Resistance Measurement Frequency: 2083 Hz
Current Measurement Frequency: 47 Hz to 800 Hz
Automatic Power-Off: After 5 minutes of inactivity
Overvoltage Protection Categories:
Category IV, 600 VAC, Pollution Degree 2
Operating Conditions:
–20 °C to 55 °C (-4 °F to 131 °F), 10% to 90% relative humidity
Storage Conditions: –40 °C to 70 °C (–40 °F to 158 °F), 10 to 75% relative humidity
Remove battery
Battery: 4 x 1.5V LR6 (AA) alkaline or 4 NiMH batteries
Statement of Conformity
Greenlee Textron Inc. is certified in accordance with ISO 9001 (2000) for our Quality Management Systems.
The instrument enclosed has been checked and/or calibrated using equipment that is traceable to the
National Institute for Standards and Technology (NIST).
Overvoltage Installation Categories
These definitions were derived from the international safety standard for insulation coordination as it applies
to measurement, control, and laboratory equipment. These overvoltage categories are explained in more
detail by the International Electrotechnical Commission; refer to either of their publications:
IEC 1010-1 or IEC 60664.
Overvoltage Category I
Signal level. Electronic and telecommunication equipment, or parts thereof. Some examples include
transient-protected electronic circuits inside photocopiers and modems.
Overvoltage Category II
Local level. Appliances, portable equipment, and the circuits they are plugged into. Some examples include
light fixtures, televisions, and long branch circuits.
Overvoltage Category III
Distribution level. Permanently installed machines and the circuits they are hard-wired to. Some examples
include conveyor systems and the main circuit breaker panels of a building's electrical system.
Overvoltage Category IV
Primary supply level. Overhead lines and other cable systems. Some examples include cables, meters,
transformers, and other exterior equipment owned by the power utility.
30