Greenlee CMGRT-100A Manual De Instrucciones página 6

Important Safety Information
Electric shock hazard:
• Unless measuring voltage, current, or frequency, shut off and lock out power. Make sure that all capacitors
are discharged. Voltage must not be present.
• Set the selector and connect the test leads so that they correspond to the intended measurement. Incorrect
settings or connections can result in incorrect measurements or damage to the unit.
• Using this unit near equipment that generates electromagnetic interference can result in unstable or inaccu-
rate readings.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Do not change the measurement function while the test leads are connected to a component or circuit.
• Do not clamp the jaw around a conductor carrying a frequency greater than 400 Hz. The magnetic circuitry
may reach a hazardous temperature if this frequency is exceeded.
Failure to observe these precautions may result in injury and can damage the unit.
Electric shock hazard:
• Do not attempt to repair this unit. It contains no user-serviceable parts.
• Do not expose the unit to extremes in temperature or high humidity. Refer to "Specifications."
Failure to observe these precautions may result in injury and can damage the unit.
6