Hitachi DH 20DV Manual De Instrucciones página 19

6. Using depth gauge (Fig. 16)
(1) Loosen the knob on the side handle, and insert the
depth gauge into the mounting hole on the side
handle.
(2) Adjust the depth gauge position according to the
depth of the hole and tighten the knob bolt se-
curely.
7. How to use the drill bit (taper shank) and the
taper shank adaptor.
(1) Mount the taper shank adaptor to the rotary ham-
mer. (Fig. 17)
(2) Mount the drill bit (taper shank) to the taper shank
adaptor. (Fig. 17)
(3) Turn the switch ON, and drill a hole in prescribed
depth.
(4) To remove the drill bit (taper shank), insert the cot-
ter into the slot of the taper shank adaptor and
strike the head of the cotter with a hammer sup-
porting on the rests. (Fig. 18)
Side handle
Fig. 16
Drill bit Taper shank
adapter
Fig. 17
Cotter
Rests
Fig. 18
English
Mounting hole
Depth
gauge
Front cap
Grip
Taper shank
adaptor
19