Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEp 4
WAVY WASHER (J)
HANDLEBAR SHAFT
REAR MAST COVER
LEFT UPPER
HANDLEBAR
LEFT LOWER
HANDLEBAR
MAIN FRAME
RIGHT UPPER
HANDLEBAR
WASHER (I)
BOLT (C)
BOLTS (H)
RIGHT LOWER
HANDLEBAR
STEp E dIAGRAM
WASHER (I)
BOLT (C)
HARdWARE fOR STEp 4:
BOLT (H)
20 mm
Qty: 8
WASHER (I)
34 mm
Qty: 2
A
Open hardware for step 4.
B
Slide 1 wavy washer (J) onto each handlebar
shaft.
C
Slide the left lower handlebar onto the
handlebar shaft. Be sure the left lower
handlebar is positioned the same as shown in the
diagram.
D
Slide the left upper handlebar onto the
handlebar shaft. Using 4 bolts (h) connect
the upper and lower handlebars as shown
in the diagram. Do not tighten any bolts until all 4 are
started.
E
Secure the handlebar assembly using 1
washer (i) and 1 bolt (C). NOTE: be sure to
attach washer (i) as shown in STEP E diagram.
F
Repeat steps B–E on the opposite side.
BOLT (C)
16 mm
Qty: 2
WAVY WASHER (J)
23 mm
Qty: 2
13
Publicidad
Tabla de contenido
