Replace The Blades; To Replace The Blades; Troubleshooting - Husqvarna AUTOMOWER 105 Manual De Usuario

Contact your local Husqvarna representative to replace
the battery.

5.4 Replace the blades

WARNING:
the right type. Husqvarna can only
guarantee safety when using original blades.
Only replacing the blades and reusing the
screw can result in a screw wearing during
mowing. The blades can then be propelled
from under the body and cause serious
injury.
Replace worn or damaged parts for safety reasons.
Even if the blades are intact, they should be replaced on
a regular basis for the best mowing result and low
energy usage. All 3 blades and screws must be replaced
at the same time to obtain a balanced cutting system.
Use Husqvarna original blades embossed with the
crowned H-mark logotype, refer to
page 28 .

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on messages, refer to the
complete Operator's manual on Husqvarna's website (www.husqvarna.com). If the same message appears often or if
you still cannot find the reason for the fault, contact your local Husqvarna representative.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as when gardening
with a shovel. Breaks can also be due to the wire being stretched excessively during installation. A wire break can be
located by gradually halving the distance of the loop where the break may have occurred, until there is only a very
short section of the wire left. Refer to the complete Operator's manual on Husqvarna's website (www.husqvarna.com).
1418 - 007 - 17.09.2020
Use blades and screws of
Warranty terms on
6 Troubleshooting

5.5 To replace the blades

1. Switch off the product with the main switch or the
ON/OFF button.
2. Turn the product upside down. Place the product
on a soft and clean surface to avoid scratching the
body and the hatch.
3. Rotate the skid plate so that its holes align with the
screws for the blade.
4. Remove the 3 screws. Use a straight slot or cross-
tip screwdriver.
5. Remove each blade and screw.
6. Fasten new blades and screws.
7. Check that the blades can pivot freely.
Troubleshooting - 19