To Replace The Blades; To Adjust The Anti-Scalp Rollers - Husqvarna TS 242XD Manual De Usuario

b) Turn the lift adjustment nut clockwise to lift the
cutting deck.
9. Measure the front and rear distance again.
10. Adjust until the front end of the blade is 1/8–1/2 in
(3.1–12.7 mm) lower than the rear end.
11. Hold the lift adjustment nut in position with the
wrench and tighten the jam nut.

To replace the blades

For the best results, keep the mower blades sharp.
Replace bent or damaged blades.
CAUTION:
blade approved by the manufacturer. It is
dangerous to use a blade not approved by
the manufacturer of the product. This can
cause damage to the product and void your
warranty.
1. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 13 .
2. Remove the bolt (A) by turning it counterclockwise
and remove the blade (B).
D
B
A C
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
3. Install the new or sharpened blade and the bolt.
CAUTION:
the blade must align with the star (D) on
the mandrel assembly (E).
4. Torque the bolt to 45–55 ft-lbs (62-75 Nm).
To remove the drive belt for the cutting deck
1. Park the product on a level surface and engage the
parking brake. Refer to
the parking brake on page 14 .
2. Put the cutting deck in the lowest position. Refer to
To set the cutting height on page 13 .
3. Remove the dirt and grass around the mandrels and
from the top surface of the cutting deck.
1932 - 004 - 13.10.2022
Use only a replacement
E
D
B
E
A C
The blades on the
The center hole (C) in
To engage and disengage
4. Remove the drive belt (A) from the clutch pulley (B)
on the engine shaft.
C
5. Remove the drive belt from the mandrel pulleys (C)
and the idler pulleys (D).
To install the drive belt for the cutting deck
1. Install the drive belt (A) around the mandrel pulleys
(B).
B
CAUTION:
correctly in all the grooves on the cutting
deck pulleys. The drive belt can become
damaged if it is not installed correctly.
Note:
You must twist the drive belt 180° at 2
positions (X) to align with the pulleys. Make sure that
the thinner part of the drive belt is in the direction of
the groove in each pulley.
2. Install the drive belt around the idler pulleys (C).
3. Install the drive belt around the clutch pulley (D) on
the engine shaft.
4. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 13 .

To adjust the anti-scalp rollers

The anti-scalp rollers keep the cutting deck in the
correct position on the ground and prevent lawn scalping
in most terrain conditions. The anti-scalp rollers are
adjusted correctly when they are slightly off the ground
when the cutting deck is at the necessary cutting height.
A
D
B
E
A
C
D
E
X
Put the drive belt
X
25