Cleaning And Maintenance; Technical Specifications - HQ-Power VDPLW1036 Manual Del Usuario

DMX512 Chain with Termination
DMX512 Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This start address is the channel number from which the device starts to "listen" to the DMX
controller. Enter the correct number and read it from the display located on the base of the
VDPLW1036. You can use the same starting address for a whole group of devices or enter an
individual one for every device. When all devices have the same address, all the VDPLW1036s will
"listen" to the control signal on one particular channel. In other words: changing the settings of one
channel will affect all devices simultaneously. If you set different addresses, each device will "listen"
to a separate channel number. Changing the settings of one channel will only affect the device in
question. In the case of the 3-channel VDPLW1036, you will have to set the start address of the
first VDPLW1036 to 1, the second VDPLW1036 to 4 (1 + 3), the third to 7 (4 + 3) and so on.
7.

Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with e.g. do not drill extra
holes in mounting supports, do not change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician
maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts.
8. Contact your dealer for spare parts if necessary.
8.

Technical Specifications

Power Supply
Power Consumption
Fuse
LEDs
DMX
Dimensions
Total Weight
Max. Ambient Temperature
Max. Housing Temperature
Use this device with original accessories only. Velleman Components nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.hqpower.com. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman
Components nv. All worldwide rights reserved. No part of this manual may be copied, reproduced,
translated or reduced to any electronic medium or otherwise without the prior written consent of the
copyright holder.
VDPLW1036_v2
A DMX terminator is recommended for installations where the DMX cable has
to run a long distance or is in an electrically noisy environment (e.g. discos).
The terminator prevents corruption of the digital control signal by electrical
noise. The DMX terminator is simply an XLR plug with a 120Ω resistor
between pins 2 and 3, which is then plugged into the XLR output socket of
the last device in the chain.
Please see illustrations.
230VAC/50Hz
40W
T1A, 250VAC (5 x 20mm) (order code FF1N)
302
3-pin XLR
176 x 294 x 136mm
2.5kg
45°C
60°C
6 HQPOWER™