Control Panel; Charging The Internal Battery Of The Instant Power - Schumacher Electric INSTANT POWER IP-95C Manual Del Usuario

Ocultar thumbs Ver también para INSTANT POWER IP-95C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.7
have plenty of fresh water and soap nearby in case battery acid contacts your
skin, clothing or eyes.
2.8
wear complete eye and body protection, including safety goggles and
protective clothing. Avoid touching your eyes while working near the battery.
2.9
If battery acid contacts your skin or clothing, immediately wash the area with
soap and water. If acid enters your eye, immediately flood the eye with cold
running water for at least 10 minutes and get medical attention right away.
2.10
Stay clear of fan blades, belts, pulleys and other parts that may cause injury.
2.11
Clean the battery terminals before using the jump starter. During cleaning,
keep airborne corrosion from coming into contact with your eyes, nose and
mouth. Use baking soda and water to neutralize the battery acid and help
eliminate airborne corrosion. Do not touch your eyes, nose or mouth.
2.12
Determine the voltage of the battery by referring to the vehicle owner's manual
and make sure that the output voltage of the jump starter is correct.
2.13
Make sure that the Instant Power™ cable clips make tight connections.
3.

CONTROL PANEL

4.

CHARGING THE INTERNAL BATTERY OF THE INSTANT POWER™

IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH
USE AND EVERY 30 DAYS TO kEEP THE INSTANT POWER™ INTERNAL
BATTERY FULLY CHARGED.
4.1
LED Indicators:
TO ChECk ThE INTERNAL bATTERY'S ChARgE STATUS, PRESS ThE
bATTERY STATUS bUTTON ON ThE FRONT OF ThE INSTANT POwER™.
The LED lights will indicate the charge level as follows:
A red LED
recharge the Instant Power™.
A yellow LED
be used but should be recharged as soon as possible.
A green LED
The CHARGING (red) LED
(connected to an AC power source.) At full charge, the CHARGED (green)
LED will light.
4.2
Charging the Internal Battery using the Built-In Charger:
1.
To charge, plug an 18 gauge (AWG) or larger extension cord into the
charger plug on the left side of the Instant Power™. (Extension cord not
included; must be purchased separately.)
indicates a 50% or less charge and you should immediately
indicates a 50 to 75% charge. The Instant Power™ may
indicates the internal battery is fully charged.
indicates the Instant Power™ is charging
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Instant power ip-125c

Tabla de contenido