Operating Instructions - Schumacher Electric INSTANT POWER IP-95C Manual Del Usuario

2. Plug the extension cord into a 120V AC electrical wall outlet.
3.
The CHARGING (red) LED
4. The CHARGED (green) LED
full charge. This could take up to 72 hours due to the age and condition
of the battery. The charger will automatically go into maintain mode and
maintain the battery at full charge without damaging it.
5. Charge the Instant Power™ as soon as possible after use.
battery.
You may also charge the internal battery while driving, using the male-to-
male charger cable (p/n 38-99-001564 – not included). Insert one end of
the accessory cable into the 12V DC power outlet and the other end into the
vehicle's accessory outlet (lighter socket). Completely disconnect the charger
cable when the engine is not running.
do not operate during this method of charging. Using this method to charge the
battery overrides the maintain mode and the battery can be overcharged.
Monitor the progress of the battery and when it reaches a full (100%) charge,
disconnect the charger. Do not leave the battery unattended or it could explode
causing property damage or personal injury.
5.

OPERATING INSTRUCTIONS

5.1 Jump Starting a Vehicle Engine
battery.
1. Turn vehicle's ignition OFF before making cable connections.
2. For a negative grounded system, clamp the red clip (+) to the positive
terminal of the battery.
NOTE: In the rare case of jump-starting a vehicle that has a positive-grounded
vehicle electrical system, connect the NEGATIVE black clip (-) to the negative
terminal (-) of the vehicle battery. Then connect the POSITIVE red clip (+) to
an unpainted and unmoving part of the vehicle chassis or engine block. If you
are unsure of the nature of the vehicle's electrical grounding system, check the
owner's manual of the vehicle. To disconnect the clips, reverse the order.
3. Clamp the black clip (-) to an unpainted and unmoving part of the chassis
or engine block.
Risk of Explosion.
If you have connected the clips backwards, an audio alarm will
sound. DO NOT turn the ON/OFF switch to the ON
could cause serious damage to the Instant Power™ or the vehicle.
Reverse the connections and the audio alarm will stop.
4.
Turn the ON/OFF switch to the ON
5. Crank the engine. If the engine does not start within 5-8 seconds, stop
cranking and wait at least 1 minute before attempting to start the vehicle
again. (This permits the battery to cool down.)
6. After the engine starts, disconnect the black clip (-) and then the red clip (+)
in that order.
7. Recharge the Instant Power™ as soon as possible after use.
Do not use the Instant Power™ while charging the internal
The CHARGING (red) LED and the CHARGED (green) LED
Do not use the Instant Power™ while charging the internal
•
will light indicating charging.
will light when the battery has reached
position.
4
•
position. This