Publicidad
Idiomas disponibles
Idiomas disponibles
Eliminating
minor faults yourself
Before you call customer
service:
-
Please check whether you can eliminate the fault yourself based on the following
information.
-
Run an appliance
self-test (see Appliance
self-test).
Customer
service will charge you for advice, even if the appliance
is still under guarantee.
Fault
Possible
cause
Remedial
action
Temperature
differs
greatly
from the set value.
In some cases it is adequate
to switch
off the appliance
for 5 minutes.
If the temperature
is too high, wait
a few hours and check whether the
temperature
has approached
the set
value.
If the temperature
is too low, check the
temperature
again the next day.
No display
on the display
panel.
The mains plug of the appliance
is not
Check whether the power is on,
in the socket properly. The fuse for the
the fuse must be switched
on.
domestic
supply is switched
off.
Warning
signal
sounds
and the
temperature
display
on the
freezer
compartment
flashes.
The freezer compartment
is too warm!
Frozen food is at risk!
- The ventilation
openings
have been
covered.
- Freezer compartment
door is open.
- Too much food was placed in the
freezer compartment
at once.
Press the "alarm/lock"
button to switch
off the warning signal and the flashing
display.
The warmest temperature
reached in
the freezer compartment
is indicated
on the temperature
display of the
freezer section for ten seconds.
m
Frozen food which has started
thawing or which has thawed can
be refrozen if meat and fish were
above 37 °F (+3 °C) for not more
than one day or other frozen food
was above 37 °F (+3 °C) for not
more than three days.
Condensation
forms
on the
discharge
unit of the
dispenser.
The environment
is to humide.
Switch on the condensation
heating.
To switch off the condensation
heating:
press the switch to "0".
The interior
light is not
functioning.
The light switch for the freezer or
refrigerator
compartment
is sticking.
Check whether the light switch can
move.
The LED light is defective.
See "LED light" section.
The appliance
becomes
slightly
louder for a brief
period.
Not a fault!
Your appliance
is designed
to save energy. Under certain
conditions
(e.g. activation
of the Super function)
the appliance
must work
harder for a brief period and therefore
becomes
slightly louder.
25
Publicidad
Capítulos
