Remote Control; Before Operation - Aiwa XR-MS3 Manual De Instrucciones

REMOTE CONTROL

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R03 (size AAA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To use the remote control
• Buttons on the remote control with the same names as those
on the main unit can be used instead. There are operations
performed by both the main unit and the remote control, but
there are operations performed by the remote control only.
Read this manual for each operation and the buttons that can
be used.
• Some buttons on the remote control have two different functions.
To use the function on the button, simply press the button. To
use the function on the plate above the button, press the button
while pressing SHIFT.
SHIFT
NOTE
• The l/d button on the remote control has the same function
as the d button on the main unit.
• If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
6
ENGLISH
R03 (AAA)

BEFORE OPERATION

zCD EJECT
POWER
TUNER/BAND
ENTER/
ILLUMINATION
PHONES
To turn the unit on
Press one of the following buttons.
POWER:
The unit is turned on and enters the previously selected function
mode.
TUNER/BAND:
The unit is turned on and tuned in to the previously received
radio station.
CD on the remote control:
The unit is turned on and the loaded CD begins to play.
If you load a CD or press z CD EJECT to remove the CD while
the power is off, the unit will turn on and the CD function will be
selected automatically.
TAPE on the remote control:
The unit is turned on and the loaded tape begins to play.
Pressing AUX on the remote control also turns the unit on.
To turn the unit off
Press POWER again.
Turning on/off the illumination
The unit has two illumination lights; one around VOLUME/MULTI
JOG, and the other at the CD insertion slot.
These illumination lights can be turned on in one of the three
different colors.
While the power is on, press ENTER/ILLUMINATION on the main
unit, or press ENTER/ILLUMINATION while pressing SHIFT on
the remote control.
This turns on/off the illumination and changes its color in the
following order:
1 Turns on in blue
2 Turns on in orange
3 Turns on in purple
4 Turns off
NOTE
• The above operation is not possible when ENTER/
ILLUMINATION is used as the ENTER button, i.e. when setting
the clock, etc.
• Turning on/off the illumination lights is not possible during the
demo display or when the display brightness is set to the darker
display (page 7).
Using headphones
Connect headphones with a stereo mini plug (ø3.5mm,
to the PHONES jack .
No sound is heard from the speakers while the headphones are
plugged in.
TUNER/BAND
SHIFT AUX
CD
POWER
TAPE
ENTER/ILLUMINATION
1 / inch)
8