Installation Instructions - Kenmore 11027542600 Instrucciones Para La Instalación

INSTALLATION INSTRUCTIONS
2. Firmly grasp the power cord and pull to completely remove
_(!}_;©_(} '_}_ _,,_4}_i_;_:_::t *_ " the power cord, cord restraint, and pin from the rear panel.
Excessive Weight Hazard __:__
Use two or more people to move and install washer.
Failure to do so can result in back or other injury. /
/
NOTE: To avoid floor damage, set the washer onto cardboard
before moving across floor.
Removing the shipping material is necessary for proper
operation. If the shipping material is not removed, the washer will
make excessive noise.
1. Move the washer to within approximately 3 ft (90 cm) of its
final location.
2=
3.
The washer must be in the upright 3osition and not tilted
before removing the shipping material.
Locate the yellow shipping materials on the rear of the
machine, near the bottom. Follow the steps for your particular
model, either the one with the straight power cord and cord
restraint or the looped power cord version.
Straight power cord
3=
4=
Confirm that the power cord restraint (A), and pin (B) are
removed.
........ :X::::::: ...... ......
A. Power cord restraint B. Pin
To remove the power cord from the cord restraint, push the
power cord in, press TAB, and then pull the power cord out.
1=
!
!
Straight power cord
Remove power plug and yellow strap from machine base to
release the rear leveling system.
Looped power cord
Y
Looped power cord