babymoov Babyphone Premium Care Instrucciones De Uso página 19

5. Now short press again the power ON/OFF button
and BU should change steady green while two beep sound is heard in PU with the corresponding BU number
icon (33) or (34) being shown up.
6. Short press button
the corresponding BU number show up. The on this BU change from flashing to become steady green.
7. Long press button (1) and (18) to switch off all BU and PU and then switch them on again, the baby monitor
is now ready for operation.
8. In case BU and PU cannot communicate with each other, repeat pairing process again.
N.B. If originally there is only one BU working with PU, after purchasing the new extra BU at later stage, it is necessary
to perform pairing process again with all the three units together.
A/ TRANSMITTER
1. Long press the power ON/OFF button
well as the assigned baby unit no. (15) should light up steady green while the room temperature indicator 9
starts showing the baby's room temperature. To turn off, long press the button 1 again.
2. Place the unit about 1 m from the crib with the microphone (7) facing towards the baby.
3. Short press the power ON/OFF button
menu icon (4) for over 2 sec to enter programming mode, the microphone icon
Adjust the microphone sensitivity by touching the up/down icon
transmit whenever the microphone (7) picks up a sound at your desirable loudness level. The temperature
indicator (9) will change during adjustment. The higher the number, the more sensitive is the microphone (7) to
sound. There are total 5 levels of microphone sensitivity. When the maximum level is reached, further touch of
the up icon (3) will set the unit into continuous transmission mode (i.e. the unit will transmit even without detecting
a sound) and the icon
power ON/OFF button
show the setting of microphone sensitivity under standby mode.
(1) of the remaining BU, two beep sound is heard in PU with the flashes two times and
OPERATION
(1) for 3 sec to switch on the unit. The power on icon
(1) to light up the touch key icons
NO
(12) as well as transmission icon
VOX
(1) to confirm your selection and exit from menu. Short touch of menu icon
L'émetteur est sur le mode de transmission continue
BABYPHONE PREMIUM CARE • Instruction manual
(1) of one BU. If pairing is successful, the on both PU
(2) and (3) such that the unit will be set to
(11) will light up steady green. Short press the
aa aa . Touch and hold the
(12) will light up.
(10) as
(4) will
19