Customer Service - Zwilling ENFINIGY 53000 Manual De Instrucciones

Fault / Customer Service / Disposal
Problem
Liquid runs out of the blender
bowl.
A program symbol, the dis-
play and the power button
are flashing.
All program symbols and the
display on the blender base
are flashing and three beeps
sound.
It is not possible to start the
mixing process.

Customer service

Please contact our customer service should you encounter any problems with your blender.
Detailed information on service, repairs, warranty and product registration can be found at
www.zwilling.com/service.
28
Possible cause
The blender lid, the lid closure
or both parts are not attached
correctly.
The seal of the blender lid is
broken.
The blender bowl is overfilled.
An automatic program has
been interrupted. The flashing
indicates the interruption.
The blender bowl and the lid
have been removed during
operation.
The motor has overheated.
The blender bowl or the lid is
not attached correctly.
The blender has been stopped
and the selector switch has
been moved with the lid open.
Remedy
Attach the blender lid correctly
and seal it with the lid closure.
The seal must be exchanged by
customer service.
Reduce the number of ingredients
or the quantity.
Press the power button again to
continue the automatic program.
Reattach the blender bowl or lid
and continue as desired.
Put the selector switch in the on/
off position, unplug the appliance
and wait 30 minutes.
Place the blender bowl on the
base with the handle facing to
the right or front or attach the lid
correctly.
Put the selector switch in the on/
off position, press the power
button and then switch the appli-
ance back on.
GB