Ryobi RY13050 Manual Del Operador página 11

WARNING:
Be certain all knobs are fully tightened before operating
equipment; check them periodically for tightness during
use to avoid serious personal injury.
INSTALLING LOWER HANDLEBAR
See Figure 2.
 Remove two handlebar knobs and bolts from the hardware
bag.
 Place the lower handlebar into the openings on the edger
frame. Make sure the hole for the hook screw is on the
right side as shown.
NOTE: Do not allow throttle cable to become pinched
when installing the handlebar.
 Insert the bolts through the holes in the handlebar and
frame.
 Thread handlebar knob onto bolt and tighten securely.
Repeat with other side.
ASSEMBLY
INSTALLING UPPER HANDLEBAR
See Figure 3.
 Remove two handlebar knobs and bolts from the hardware
bag.
 Position upper handlebar onto lower handlebar. Make
sure the throttle cable and throttle trigger is on the right
side as shown.
NOTE: Do not allow throttle cable to become pinched
when installing the handlebar.
 Insert the bolts through the holes in the lower handlebar
and upper handlebar.
 Thread handlebar knob onto bolt and tighten securely.
Repeat with other side
 Place the throttle cable in the clip located on the upper
handlebar.
INSTALLING HOOK SCREW FOR STARTER
GRIP
See Figure 4.
 Locate plastic wing nut and hook screw.
 Insert hook screw through hole on right side of lower
handlebar.
 Pull starter grip and rope into hook screw.
 Thread wing nut onto hook screw and tighten
7 — English
securely.