Installing / Removing Battery Pack - Black and Decker LCS1020 Manual De Instrucciones

FUNCTIONAL DESCRiPTiON
LOS1020
LCS1240
• Trigger switch
2• Lock-off button
3. Front hand guard
4• Guide bar
5. Saw chain
6• Sprocket cover
7. Bar adjust locking knob
8. Chain tensioning knob
INSTALLING / REMOVING
BATTERY PACK
zhWARNING:
Make certain the lock-off
button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert
battery pack into tool until an audible click
is heard, as shown in Figure A. Ensure
battery pack is fully seated and fully latched
into position.
TO REMOVE BATTERY PACK:
Depress the battery release button in the
back of the battery pack and pull battery
pack out of tool (figure A).
PREPARING YOUR CHAIN
SAW FOR USE
zhWARNING:
Read and understand
all instructions. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious personal injury•
9• Guide bar scabbard
10• Rear handle
11• Front handle
12• 20V Battery (not shown)
13• 40V Battery (not shown)
14. Oil cap
15. Oil primer bulb
16. Oil level indicator