Tabla de contenido
Publicidad
• Connect the battery in the model.
• The LEDs on the quadrocopter now flash
rhythmically.
• Switch on the controller at the power
switch.
• Push the left-hand joystick, i.e., the throt-
tle control, completely upwards and then
completely downwards.
• The binding has now been successfully
established.
• The LED on the controller now lights con-
tinuously.
• After approx. 5½ minutes, the controller
switches off. Please repeat the link pro-
cedure for renewed use.
• WARNING! Immediately after switch-
ing it on, place the Quadrocopter on
a flat and level surface. The gyro-sys-
tem will then set itself automatically.
Description of the Quadrocopter
5
1. Rotor system
2. Rotor protection cage
3. LEDs
4. Video camera
6
5. Battery cable
6. Quadrocopter connecting plug
7. SD-card slot
8. Video LED
Range of functions of the remote
control
7
1. Aerial
2. Power (ON / OFF)
3. Control LED
4. Gas
Circling
5. Forwards / backwards
right / left banking
6. Trimmer for right / left banking
7. Trimmer for forwards / backwards
8. Trimmer for rotation
9. Looping Button
10. Headless Mode
11. Start rotor' button
12. 'Auto-landing' button
ENGLISH
13. 'Auto-start & fly to 1.5 m' button
14. Light (on/off)
15. Beginner/Advanced switch
(30%/60%/100%)
16."Take video"/record video button
17. "Take picture"/take photo button
3
18. Battery compartment
Choosing the flight area
When being prepared for the first flight
8
you should choose a closed room
which is as large as possible without
any persons or obstacles. Due to its
size and controllability, experienced pi-
lots may be able to fly the Quadrocop-
ter in relatively small rooms. For your
first flights we strongly recommend
you choose a room with a minimum
floor space of 5 x 5 metres and 2.40
metres in height. After having trimmed
your Quadrocopter for flight and made
yourself familiar with the controller and
its functions you may start flying in
smaller and less open environments.
To be used in domestic area (house and
garden) only.
There must be no persons or
objects such as pillars between the con-
troller and the Quadrocopter to obstruct
direct connection.
Checklist for flight preparation
This checklist is not a substitute for the con-
tents of the operating instructions. Although it
can be used as a quick-start-guide, we strong-
ly recommend you first to read the operating
instructions in detail before you proceed.
• Check the contents of the package.
• Connect the charging unit to the source of
power.
• Charge the lipo-battery as described in the
section "Recharging the LiPo rechargeable
battery".
• Fit 2 AA batteries in the controller, making
sure their polarity is correct.
• Look for a suitable environment for flying.
20
Publicidad
Tabla de contenido
