Short Description Of The Press Device (Fig. 1); Rechargeable Battery - NovoPress ACO401 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
ACO401
EN
Battery charger
For information on the function and operation of the battery charger and the rechargeable
batteries, please consult the Operating Manual provided for the battery charger.
6

Short description of the press device (Fig. 1)

The ACO401 press device comprises the press device (1) and a fixed adaptor jaw (2). The
head with the adaptor jaw can be rotated through 180°. It is only possible to adjust the head
before the pressing operation. The head cannot be rotated while the pressing operation is being
performed.
To carry out the pressing operation, hold the device tightly on handle (3) and on grip (4) on the
adaptor jaw.
6.1
Automatic press cycle
The device features an automatic press cycle. This ensures that the pressing operation is
completed every time. For safety reasons, the automatic press cycle only switches on when the
pressing operation has started, i.e. from when the fitting starts to be shaped.
After the automatic press cycle has been triggered, the green LED (5) goes out and the
pressing operation runs automatically. The pressing operation can then only be stopped by
pressing and holding release button (6). After the pressing operation has been completed, the
motor automatically switches off and the green LED lights up again.
If start button (7) is released before the automatic press cycle begins, the piston in the press
device moves back to its starting position. The pressing operation will not have been completed.
The pressing operation must be triggered again.
6.2
Release button
In the event of an emergency, the pressing operation can be stopped at any time by pressing
and holding release button (6). The piston in the press device then returns to its starting
position.
6.3

Rechargeable battery

6.3.1
Removing the battery (Fig. 2)
Press the two release buttons (A) inwards (1) and then remove battery (2).
6.3.2
Inserting the battery (Fig. 3)
Slide the battery onto the device as illustrated until it clicks in.
Information!
The batteries are not charged when delivered.
Therefore
– Charge the batteries before using them for the first time.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido