Zipper Maschinen ZI-STE1000IV Manual De Instrucciones página 33

1. Dismantle the repair cover of the spark
plug (Fig. Z).
2. Dismantle the cap of the spark plug.
3. Clean out the filth around the base of the
spark plug.
4. Dismantle the spark plug with a spanner.
B – Hold of the handle (Fig. AA)
C – Banner of the spark plug (Fig. AA)
D – Cap of the spark plug (Fig. AA)
5. Examine the spark plug with your naked eyes. If the insulator has crazed or has fragments,
you should discard the spark plug. If the old spark plug needs to be used continually, you
must clean it up with a brush.
6. Measure the clearance of the spark plug with a gauge. The clearance should be 0.6nm to
0.7nm. (Fig. AB)
7. Install the spark plug carefully by hand. Pay attention not to overlap the screw thread.
8. After installing a new spark plug by hand, screw it with a spanner for a half circle in order to
press the washer tightly. If an old spark plug is installed, you only need to screw it from one
eighth circle to one fourth circle after it is fixed.
9. Re-install the cap of the spark plug.
2.9 TRANSPORT / STORAGE
In order to avoid the generator leaking oil during transport or temporary storage, make sure to
switch off the generator, keeping it at a standing pose under normal operations. After the engine
is totally cooled, turn the ventilating pole of the fuel-filling lid to the "close" position thoroughly.
When transporting the generator:
Do not let the fuel spill out of the fuel tank. (The top of the fuel-filling tank should have no
fuel.)
When the generator is placed on vehicle, do not run the engine. You should take the
ator down from the car and operate it in the draught.
When you take the generator to the car, avoid exposing it to sunshine. If it is put in sealed
carriage for a long time, the high temperature of the carriage may cause the fuel to boiling
away, thus leads to burn.
The cars loaded with generator should not bump on the uneven roads for a long time. If it
has to travel on such roads, the fuel in the fuel tank should be discharged thoroughly in ad-
vance.
Before the generator is put into a long-time storage, you should:
1. Make sure the storage area is clean and dry.
2. Discharge the fuel thoroughly:
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
A T T E N T I O N
The spark plug must be fixed
firmly, or else it will become
very hot and damage the gen-
erator.
Do not use the spark plug whose
thermal measurement range is not
suitable.
gener-
Seite 33