Sears KENMORE ELITE 596.72282200 Manual De Uso página 18

Ocultar thumbs Ver también para KENMORE ELITE 596.72282200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Trouble
Shooting
OPERATION
(continued)
POSSIBLE
CAUSE
TOPIC
Refrigerator r unstoo
SOLUTION
Controls need to be adjusted.
Door is not closing properly.
See "Installing Your Refrigerator-How to Adjust the
Temperature Controls" section on how to adjust your controls.
See "Installing Your Refrigerator-How to Level Your
Refrigerator" section on how to properly level unit.
Check gaskets for proper seal. Clean, if necessary. See
section on "Hints and Care-How to Clean Your Unit" for
instructions.
Check for internal obstructions that are keeping door from
closing properly (i.e. improperly closed drawers, ice buckets,
oversized or improperly stored containers or foodstuffs, etc.)
ICE
Unit is leaking water
Ice forms in inlet tube to ice
maker
Water flow is slower than
Plastic tubing was used to complete water
connection.
Improper water valve was installed.
Water pressure is low.
Freezer temperature is too high.
Water pressure is low.
Improper water valve was installed.
Sears recommends using copper tubing for installation.
Plastic is less durable and can cause leakage. Sears is
not responsible for property damage due to improper
installation or water connection.
See section on "Installing Your Refrigerator-How to
Connect the Water Supply" for Instructions. Self-piercing and
3A6" s addle valves cause low water pressure and may clog the
line over time. Sears is not responsible for property
damage due to improper installation or water connection.
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for units with water
filters.
See "Installing Your Refrigerator-How to Adjust the
Temperature Controls" section on how to adjust your controls.
Freezer is recommended to be between Oto 2°F
(-18 to -17 o C).
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for units with water
filters.
See section on "Installing Your Refrigerator-How to
Connect the Water Supply" for instructions. Self-piercing and
3A6" s addle valves cause low water pressure and may clog the
line over time. Sears is not responsible for property
damage due to improper installation or water connection.
]8

Publicidad

Tabla de contenido
loading

Tabla de contenido