Publicidad
Idiomas disponibles
Idiomas disponibles
Models 45-KFA / 75T-KFA:
1. Use an approved siphon to drain fuel through the
fuel cap opening.
Models 135T-KFA / 190T-KFA / 215T-KFA:
1. Drain fuel through the drain plug in the bottom
of the fuel tank.
2. To remove the drain plug, pull the plug grip
downward and remove the seal head from the
drain hole in the tank. (See Figure 11)
Drain Plug
Figure 11
Using a small amount of kerosene, rinse and
swirl the kerosene inside of the fuel tank,
empty the tank fully.
4. To replace the drain plug; push the drain head
fully into the drain hole and secure by pushing
the seal cap fully into the head hole.
(See Figure 12)
Figure 12
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
Maintenance
Drain Plug Grip
(Pull Down)
Drain Plug
Fuel Tank
Seal Head
Head Flange
Seal Cap
9
WARNING
DO NOT TAMPER WITH THE UNIT. HAVE
A COMPETENT SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENT OR REPAIRS.
Use only original equipment parts. The use of
alternate or third party components can cause unsafe
operating conditions and will void your warranty.
TIP: To order OEM parts call (800)-641-6996
Flush tank every 200 hours of operation or as needed.
TIP: Follow the long term storage
with soap and water and dried thoroughly every 500
hours of operation or less depending on conditions.
every 500 hours of operation or less depending
on conditions.
additional maintenance
Lint Filter
Kerosene Forced Air Heater User's Manual
Air Output Filter
Intake Filter
End Filter
Publicidad
