Oscillation Function / Swing Function; Cleaning And Care; Overheating Protection Circuit - Unold 86450 Instrucciones De Uso

DE

OSCILLATION FUNCTION / SWING FUNCTION

EN
1. With this function it is possible to distribute the air flow over a larger area,
because the appliance swings back and forth in a specific radius.
FR
2. The oscillation function can be switched on in every mode. To do this, press
the button on the top of the appliance.
NL
3. If you want to stop the appliance in a specific position, press the button
again.
IT
4. Switch off the oscillation function before you switch off the appliance.
ES

CLEANING AND CARE

PL
1. Never use any abrasive scouring agents, steel wool, metal objects, hot clean-
ing agents or disinfectants.
2. You can remove dust in the appliance if you carefully hold a vacuum cleaner
against the air inlet and outlet grille.
3. Store the fan heater in a dry, safe place so that it is protected from dust,
shocks, heat and moisture.

OVERHEATING PROTECTION CIRCUIT

1. The appliance is equipped with an overheating protection circuit that
switches the appliance off when it is heated over 70° C.
2. If the overheating protection circuit has been tripped, switch the appliance
off, unplug the plug from the electrical outlet and let the appliance cool for
at least 10 minutes.
3. Eliminate the cause of the overheating, (e.g. excessive dust in the appli-
ance, air outlet grille is covered) and start up the appliance again.
24 von 68
Copyright UNOLD AG | www.unold.de
Switch off the appliance. To switch off the appliance, place the
rotary regulator on position "O" and unplug the mains plug.
Allow the appliance to cool completely.
Stand 24.2.2020