Makita 4131 Manual De Instrucciones página 9

Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
Carbide-Tipped Matal Blades for Many Applications
METAL SHEET
Size(mm)
t=1.5 t=3.0
X
185X36T
185X38T
185X48T
185X70T
CAUTION:
• Always use carbide-tipped saw blades appropriate
for your job. Do not cut aluminum, wood, plastics,
concrete, tiles, etc.
• Carbide-tipped saw blades for metal cutting saw
are not to be re-sharpened.
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita tool is thoroughly inspected and tested
before leaving the factory. It is warranted to be free of
defects from workmanship and materials for the period of
ONE YEAR from the date of original purchase. Should
any trouble develop during this one year period, return
the COMPLETE tool, freight prepaid, to one of Makita's
Factory or Authorized Service Centers. If inspection
shows the trouble is caused by defective workmanship or
material, Makita will repair (or at our option, replace)
without charge.
This Warranty does not apply where:
• repairs have been made or attempted by others:
005356
1. Screwdriver
2. Brush holder
cap
2
C-STUD ANGLE-STUD
50X100 45X90 50X50 50X50
t=1.6 t=3.2 t=4 t=6
X
X X X
ACCESSORIES
CAUTION:
• These
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Rip fence (Guide rule)
• Safety goggle
• Recommended Carbide-tipped saw blades &
workpiece ranges
Applications
METAL STUD REBAR
t=0.56 t=1.6
25Ga 16Ga 20
X
X X X
Excellent
• repairs are required because of normal wear and
tear:
• the tool has been abused, misused or improperly
maintained:
• alterations have been made to the tool.
IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY
INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAM-
EN0006-1
AGES FROM THE SALE OR USE OF THE PRODUCT.
THIS DISCLAIMER APPLIES BOTH DURING AND
AFTER THE TERM OF THIS WARRANTY.
MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED
WARRANTIES, INCLUDING IMPLIED WARRANTIES
OF "MERCHANTABILITY" AND "FITNESS FOR A SPE-
CIFIC PURPOSE," AFTER THE ONE YEAR TERM OF
THIS WARRANTY.
This Warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limi-
tation or exclusion may not apply to you. Some states do
not allow limitation on how long an implied warranty lasts,
so the above limitation may not apply to you.
9
accessories or
to persons. Only use
PIPE CORRUGATED SHEET
25
50X100 60
t=3.2 t=1.2 t=3.8
X X X
X
Fair
Good
attachments are
accessory or
005705
t=1.0-2.0
t=0-0.9
X X
X X
X
Not Applicable