Light Bulbs; Stainless Steel Hood Surfaces - GE Monogram ZVC48LSS Manual Del Propietário

Stainless
Do not use a steel wool pad; it will scratch
the surface.
steel hood
surfaces
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or polish.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for cleaning
the stainless steel surface.

Light bulbs

To change the light bulbs:
1. Grasp the outer trim ring and twist until reaching
2. Grasp the bulb and twist until reaching the unlock
3. Replace with the same wattage, type and size
4. Replace the outer trim ring by inserting the two
the unlock position. Then pull the ring straight out.
position. Then gently pull the bulb straight out.
bulb. Wear gloves. Do not touch bulb with your
bare fingers.
These 120 volt, 50 watt halogen bulbs with a
GU10 base are available at specialty lighting
stores and home building centers.
retaining tabs into the two tab slots, pressing the
ring flush with the surface of the hood insert and
twisting until reaching the lock position.
Care and Cleaning
Custom Hood Insert
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:
National Parts Center
monogram.com
800.626.2002
7