Surfaces; Stainless Steel Surfaces (On Some Models); Light - GE JV247 Manual De Instrucciones

Filters (Cont.)
The charcoal filter cannot be cleaned. It must be
replaced. Order filter no. WB02X10700. Replacement
filters can be ordered from your GE Appliances supplier.
If the hood is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors.
The charcoal filter should be replaced after 6 to 12
months (depending on hood usage).
To remove:
Pull down on the center of the front edge of the filter. The
filter will then slip out of the retaining tabs on the back.

Surfaces

Stainless Steel Surfaces (on some models)

Do not use a steel-wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
Painted Surfaces (on some models)
Do not use steel-wool pads or other abrasive
cleaners. They will scratch the surface.
Clean grease-laden surfaces of the hood frequently. To
clean the hood surface, use a hot, damp cloth with a
mild detergent suitable for painted surfaces. About one
tablespoon of ammonia may be added to the water. Use
a clean, hot, damp cloth to remove soap. Dry with a dry,
clean cloth.

Light

CAUTION
Let the light bulb cool completely before
removing. A warm or hot bulb may break if touched with
a moist cloth or hand.
Remove the bulb and replace it with a type A15
incandescent light bulb with an ordinary screw base,
not more than 60 Watts, or a type A17 or T2 Compact
Fluorescent (CFL) light bulb with an ordinary screw base,
not more than 13 Watts. NOTE: Use only incandescent
bulbs in models RN328, JN327, JN328 and JV338.
IMPORTANT: For installation, handling and disposal
precautions, refer to the fluorescent bulb packaging
literature.
To remove the light cover (on some models):
the side prongs are released.
you in one motion.
49-80589-7
To replace:
Slip the back edge of the filter into the retaining tabs and
push the front edge up until it snaps into place.
Replaceable charcoal filter
NOTE: DO NOT rinse, or put charcoal filters in an
automatic dishwasher.
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer
nearest you, please call our toll-free number:
National Parts Center
800.626.2002
GEApplianceParts.com
NOTE: When cleaning, take care not to come in contact
with filters and other non-enameled surfaces.
CAUTION
When cleaning the hood surfaces, be
certain that you do not touch the light bulb with moist
hands or cloth. A warm or hot light bulb may break if
touched with a moist surface. Always let the light bulb
cool completely before cleaning around it.
To replace the light cover:
the top opening.
the side prongs into the side openings.
When using an energy saving bulb in your GE
Appliances hood make sure you use either:
Light cover
GE Long Life Energy Smart™ Spiral
Product Code: 85383
Description: FLE13HT2/2/SW/CD
or
GE Long Life Energy Smart™ A17
Product Code: 47486
Description: FLE11/2/A17XL/CD
Available at www.gelighting.com
T2
®
7