DeWalt DCH243 Manual De Instrucciones página 11

Trigger Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (B). To turn the tool
off, release the trigger switch. Your tool is equipped with a brake. The
chuck will stop as soon as the trigger switch is fully released.
VARIABLE SPEED TRIGGER SWITCH
The variable speed trigger switch enables you to select the best speed
for a particular application. The farther you squeeze the trigger switch,
the faster the tool will operate. For maximum tool life, use variable
speed only for starting holes or fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the trigger switch and should be avoided.
Mode Selector (Fig. 3) FIG. 3
A CAUTION: Never change the mode while
the unit is running.
For straight drilling, rotate the mode
selector (D) until the arrow points to the drill
bit symbol (I). For rotary hammer mode,
align the arrow with the rotary hammer
symbol (J). For chipping mode, align arrow
with the chipping symbol (K).
NOTE: The mode selector (D) must be in drill, hammer or chipping
mode at all times. There are no operable positions in between.
Forward/Reverse Control Button (Fig. 2, 4)
A forward/reverse control button (C) determines the direction of bit
rotation and also serves as a lock-off button.
To select forward rotation, release the trigger switch (B) and
depress the forward/reverse control button on the right side of the tool.
To select reverse, depress the forward/reverse control button on the
left side of the tool.
The center position of the control button locks the tool in the
off position. When changing the position of the control button, be
sure the trigger is released.
NOTE: The first time the tool is run after changing the direction of
rotation, you may hear a click on start up. This is normal and does not
indicate a problem.
FIG.4
C"
UN LOCKED, LOCKED UN LOCKED,
FORWARD REVERSE
Worklight (Fig. 5) (DCH253 only)
There is a worklight (F)located on the front FIG.5
of the tool. The worklight is activated
when the trigger switch is depressed, and
will automatically turn off 20 seconds after
the trigger switch is released. If the trigger
switch remains depressed, the worklight
will remain on.
NOTE: The worklight is for lighting the
immediate work surface and is not
intended to be used as a flashlight.
10