DeWalt DCH243 Manual De Instrucciones página 12

OPERATION
_WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 6)
_ WARNING: To reduce the risk of injury, never depress the battery
release button without removing the battery pack. Depressing the
battery release button without removing the battery pack can result
in the battery pack falling out unexpectedly.
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (G) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it does
not disengage.
FIG. 6
NOTE: Operating temperature of this tool is 19 o to 104 °F (-7 o to
+40 °C). Using the tool outside of this temperature range will decrease
the life of the tool.
FUEL GAUGE BA'rI'ERY PACKS (FIG. 7)
Some DEWALT battery packs include a fuel gauge which consists of
three green LED lights that indicate the level of charge remaining in
the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge button (N).
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
FIG.N _
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please
call 1-800-4-DEWALT (1-800-433-9258) or visit our website
www.dewalt.com.
To remove the battery pack from the tool, press the release button (H)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
11