Unit Installation - GE Lumination DI Adjustable Serie Guia De Instalacion

Unit Installation

1
Cut the appropriate size hole into
ceiling tile (see table at below).
Fixture Hole
Diameter Diameter
4 in. 5 in. (126mm)
6 in. 6½ in. (165mm)
4
Option A: Mount fixture by
attaching hanger bars to
T-Grid ceiling (BH3 SKU 94890).
6
Adjust fixture height to be
flush with ceiling and secure
by tightening both adjustable
mounting bracket wingnuts.
Assembled
position
Trim ring
2
Carefully push both torsion springs
up and insert trim ring into fixture.
Release springs to secure.
RISK OF PERSONAL INJURY
Operators shall ensure no
appendages are in the path of
the torsion springs as they are a
pinch hazard when released.
T-Grid
4
Option B: Mount fixture with ½"
EMT conduit.
Note: Supplied by 3rd party.
7
Dust off any particles that may
have adhered to connection
points and heat sink during
installation process with a dry
cloth or compressed air. Twist
Infusion™ downlight module
into holder.
3
CAUTION
T-Grid
5
8
Slide hanger bars through
adjustable mounting brackets.
Assembled connector housing
Re-connect easy connector on
flexible conduit.
Slide reflector into the fixture.
Verify reflector trim is flush with
ceiling. Repeat Step 4 if trim is
not flush.
For wall wash reflectors, position
reflector so that light is directed
towards wall.