GE RGS1540Z Manual De Uso página 60

nota: it's important that once you have completed the above steps you make
sure that the water cylinder is correctly installed to prevent water freezing in The
cylinder's interior.
CaUtion: Only fill with drinking water.
iMPortant: When removing the ice cubes, pull
the handle all the way down. You will feel resistance
at this point, but you need to pull a little more so that
the ice-tray twists and releases the ice into the lower
compartment. once this point has been reached, the
process is complete.
ClEaning yoUr SMart fill iCE faCtory
When cleaning your Smart Fill ice Factory it is imperative that you only use a soft
sponge with water and a neutral soap. afterwards, leave it to dry.
do noT use a steel wool sponge or detergent to clean the SFiF (especially the
ice-bucket), as this could affect how it works, change how it looks, and affect the
flavour of your ice cubes.
ClEaning thE CylindEr
only use a soft sponge with water and a neutral soap to clean. afterwards, leave it to
dry. don't use steel wool sponges or detergents, knives or forks as these could scratch
or damage the central valve. if there's frozen water inside the cylinder, let it melt
or use tepid water to speed up the process.
60
rEMoval of iCE
1. after a while, your ice cubes will be ready for
use. To remove them, pull the handle slowly
towards you until it's fully down. at this point it
will be necessary to pull the handle a little more
forcefully until you hear the ice fall into the
lower compartment of your SMaRT FiLL iCe
FaCToRY.
2. This compartment can hold up 3 complete
releases of the ice-tray. To remove the ice,
simply lift and pull the storage box that you will
find in the lower part. This box is designed to
be brought wherever you wish. To make more
ice, repeat the process.
notE: The cylinder can only hold one
load at a time. Before repeating the
process, make sure that the tray is empty.
notE: The ice produced may vary in size.