Ferplast bluclima 50 Manual De Uso página 8

BLUCLIMA
IT
CONGRATULATIONS ON HAVING CHOSEN
THE BLUCLIMA HEATER.
EN
BLUCLIMA is the new concept from Ferplast,
the perfect world for fish created with
innovation, style and quality for total safety.
FR
BLUCLIMA built on the vast experience and
enthusiasm of the Ferplast Research and
Development team. BLUCLIMA has been
designed to give you the most reliable and
D
precise aquarium heater available on the
market. BLUCLIMA always ensures the ideal
temperature for the environment, helping
to easily create the best conditions for plants
NL
and fish.
Read the instructions carefully before
installing the heater.
ES
ATTENTION: disconnect all the appliances in
the aquarium or bowl before carrying out any
installation or maintenance work.
INSTALLING BLUCLIMA:
SK
A FEW RULES, TOTAL SAFETY.
Preliminary warnings:
• BLUCLIMA is constructed in compliance with
the relative international safety regulations
CS
(CEI EN 60335-2-55).
• Ensure that the voltage shown on the heater
label corresponds to that of your home
electrical power supply.
HU
• Do not connect the heater to the power
supply when it is not submerged in water.
• After immersing it in the water, wait a few
minutes before switching it on, so that the
SV
thermostat can adjust to the temperature of
the water.
• Always ensure the water level stays above the
'minimum water level' mark shown on the
DA
heater.
• To avoid possible breakages due to thermal
shock, the heater should be disconnected
from the power supply at least 5 minutes
RU
before taking it out of the water or before
adding or changing the water.
• The power supply cable has Z-type wiring, so
it cannot be repaired or replaced: if damaged,
the whole heater must be replaced.
PL
• The heater can be immersed in water to a
maximum depth of 1 m.
8
• The heater can be immersed in water to a
maximum depth of 1 m.
• When connecting the heater to the power
supply, ensure that the lowest point of the cable
is lower than the electrical socket so that drops
of water do not accidentally run down the cable
and into the power supply (Fig. 1).
• The heater is intended for indoor use.
• Ensure that your home is protected by an
automatic breaker switch with an operating
current of no more than 30 mA.
• The heater is NOT a child's toy, so should not be
used by unsupervised children or unfit persons.
Note: if the heater is not fitted with a power
plug, fit an approved UK 3 pin plug with a 3amp
fuse and where there is a minimum distance of
3mm between the neutral and live wires.
THE IDEAL POSITION AND RIGHT POWER.
• Position the heater at a point in the aquarium
where there is good water circulation;
otherwise the thermostat will not work at its
maximum efficiency and the set temperature
may not be reached.
• Choose a heater of the right power (Watt)
according to aquarium
temperature and
increase (Fig. 2).
INSTALLATION AND OPERATION.
• If you have a CAYMAN aquarium: insert the
heater in the special BLUWAVE filter housing
(if you have a Professional model, it should be
connected only by a qualified electrician).
• the suckers to the heater, making sure they are
positioned as in the illustration; the suckers
must only be attached to the upper part of
the heater and away from the heating element
(Fig. 3).
Install BLUCLIMA vertically in the aquarium
in an area with good water circulation; this
will ensure the best heat distribution and
thermostat operation. Attach the suckers to the
previously cleaned glass and push firmly.
• For proper operation, the water level should not
go below the 'minimum water level' mark (this
is automatically guaranteed in BLUWAVE filters).
capacity, room
required temperature