Troubleshooting Guide - senya SYCP-HB009 Manual De Instrucciones

This setting can be used to clean the insides of the glass jug. Put 750 ml of warm water with
a little washing up liquid into the blender jug and use the 'pulse' setting as above.
TROUBLESHOOTING
In the event of a problem or incorrect use of the appliance, an error code will appear on the
screen.
Code Problem
E01 Jug lid incorrectly positioned
E02 Contents overflow
E03 Disconnected thermostat wires
E04 Thermostat cut-out
E05 Liquids or ingredients too hot at
the start of the programme
3. Advice for care and storage
 Always unplug the appliance and wait for its complete stop before dismantling it.
 Never immerse the motor unit, its power cord or its plug in water or any other liquid.
Clean them with a soft, damp cloth.
 Do not clean the soup maker or the provided plastic cup in a dishwasher.
 Clean the surface of the soup maker base unit and lid with a soft, damp cloth.
 Caution: the blades under the lid are not removable and are very sharp; extreme
caution should be taken when cleaning the inside of the lid.
 Warning: The blades cannot be removed and are very sharp; be extremely careful when
cleaning the inside of the bowl.
 For tough stains, it is recommended that you leave the hot water in the soup maker for
10-15 minutes before using the clean function.

4. Troubleshooting guide

Problem
Solution
Place the lid in the correct position then
restart the programme
Reduce the contents of the blender jug
taking care not to exceed maximum fill
levels: 1.4 L (hot use), 1.75 L (cold use)
Contact our After Sales Service
Contact our After Sales Service
Allow liquids/ingredients to cool to below
65°C before starting a programme
Reason
22
Solution