Attaching The Shoulder Strap - Ryobi RY42110 Manual Del Operador

Sopladora / aspiradora
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of the product
with damaged or missing parts could result in possible
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING AND EXTENDING THE
BLOWER/VAC TUBE
See Figures 2 - 3.
 Slide the blower/vac tube into the motor housing.
 Latch into place. Be sure the latches are closed and the
tube and motor housing are securely together.
 Push the tube lock button down and pull the lower tube
out of the upper tube by holding the front bracket to fully
telescope the tube out. You will hear a "click" sound when
the tubes are fully extended and locked into place.
ASSEMBLY
ATTACHING AND REMOVING THE
VACUUM BAG
See Figure 4.
WARNING:
Never run the unit without the vacuum tube and vacuum
bag installed. Use of an improperly assembled unit could
result in serious personal injury.
 Slide opening of the plastic bracket on the vacuum bag
over the discharge outlet on the bottom of the motor
housing.
 Pull the tab on the plastic bracket out and push plastic
bracket and vacuum bag onto motor housing. Let tab
lock into slot on motor housing.
 Push clip, located on front of vacuum bag, into vacuum
bag hook, on underside of blower/vac tube.
 To remove the vacuum bag, pull the vacuum bag hook
slightly back and pull the vacuum bag clip out.

ATTACHING THE SHOULDER STRAP

See Figure 5.
 Clip the shoulder strap into the shoulder strap hook on
the rear handle.
 Adjust the shoulder strap so that it is in a comfortable
position for you.
8 - English

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido