Exit Wireless Setup; Customize Thermostat (Installer Setup) - Honeywell RedLINK FocusPRO Guia De Instalacion

RedLINK™ Installation Guide (TrueZONE™)
3

Exit wireless setup

Press at the wireless adapter to exit wireless setup (light should stop
CONNECT
flashing).
Note: The wireles adapter will automatically exit wireless setup after 15 minutes of
inactivity.
Note: If installing more than one zone panel, you must exit wireless setup before installing
an additional zone panel.
4

Customize thermostat (installer setup)

Follow the steps below to begin installer setup. At each function screen,
▲ ▼
press or to change the setting as desired, then press
the next function screen.
See tables on pages 7-9 for a description of options for each function.
FAN
To begin, press and hold the
until the display changes (about 3 seconds).
Function Setting
1
Done Back
Press DONE to save & exit.
and ▲ buttons
FAN
0
Next
6
NEXT
0
Done Back
Press ▲ or ▼ to change setting
(see tables on pages 7-9)
Press to display next
NEXT
function screen
to advance to
1
Next