Fcc Caution; Industry Canada - Bosch GLI18V-2200C Instrucciones De Funcionamiento Y Seguridad

GLI18V-2200C 11-18.qxp_GLI18V-2200C 11/5/18 10:16 AM Page 4
The manufacturer is not responsible for
radio interference
unauthorized modifications to this
equipment. Such modifications could
void the user's authority to operate the
equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful
interference, and
2) This device
interference received, including
interference that may cause undesired
operation.
NOTE! This equipment has been tested
and found to comply with the limits for a
Class B digital devices, pursuant to Part
15 of the FCC rules. These limits are
designed to
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
This device complies with Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1) this device
interference, and

FCC Caution

caused
must accept any
provide reasonable
cause harmful

Industry Canada

may not cause
user is encouraged to try to correct the
by interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
"Exposure to Radio Frequency (RF)
Signals: The wireless device is a radio
transmitter and receiver. It is designed
and manufactured not to exceed the
emission limit for exposure to radio
frequency (RF) energy set by the Ministry
of Health (Canada), Safety Code 6. These
limits are part of comprehensive
guidelines and established permitted
levels of RF energy for the general
population.
These guidelines are based on the safety
standards previously set by international
standard bodies. These standards include
a substantial safety margin designed to
assure the safety of all persons,
regardless of age and health.
This device and its antenna must not be
co-located or operating in conjunction
with any other antenna or transmitter.
(2) this device
interference, including interference
that may cause undesired operation
of the device.
-4-
must accept any