Special Safety Instructions; Putting Into Service; Using The Device - Clatronic DB 2627 Instrucciones De Servicio

43417-05-DB 2627
GB
• WARNING! The soleplate becomes hot quickly and requires a long period of
time to cool down. Do not touch!
• When the iron is not being used place it on the stand.
• Before filling the water tank pull out the plug. Do not fill the water tank above the
MAX mark!
• Clean the iron soleplate with a moist cloth without additives!
• Fill the water tank through the filling hole (2) with distilled water.
ATTENTION: Only garments are to be ironed with this device.
Ironing without steam (steam jet regulator on 0)
1. Place the device on its stand.
2. Sort the laundry according to ironing temperature. Start from the lowest
temperature to be set with the thermostat (5):
• synthetics, silk (low temperature)
• • wool (medium temperature)
• • • cotton, linen (high temperature)
3. Insert the plug in a duly installed 230V/50Hz socket with protective contact.
4. The LED (4) lights up. The operating temperature is reached when it shuts off
(approx. 3 min.) Now you can start to iron.
5. After use pull the plug out of the socket and leave the iron to cool a few minutes
(20-30 minutes) before putting it away.
Steam ironing
A high temperature is needed (cotton, linen). The amount of steam can be selected
with the steam jet regulator (1).
Position 0 = no vapor
Position 1 = low steam level
Position 2 = medium steam level
Position 3 = max. steam level
30
13.07.2004 9:42 Uhr

Special safety instructions

Putting into Service

Using the Device

Seite 30