Brother P-touch EDGE 7500 Guía De Usuario página 96

Error Message
NO FILES!
OK TO REDUCE
THE BLOCK NO.?
RECORD NOT
FOUND!
TAPE CASSETTE
CHANGED!
TEXT TOO HIGH!
XX BLOCK
TEXT TOO LONG!
TEXT TOO LONG!
XX BLOCK
VALUE OUT OF
RANGE!
80
Cause
• This message appears if no
files are stored in the
memory when you try to
recall or delete one.
• The message appears if you
select the PANEL2 Label
Type mode, and when the
number of the desired blocks
is less than that of the text
mode, the number is reduced.
• This message appears when
the specified text or record
number cannot be found in
the database.
• This message appears if the
tape cassette was changed
while the P-touch labeler
paused for the tape to be cut.
• This message appears if the
size of the text is larger than
the width of the installed
tape.
• This message appears if the
length of the text is longer
than the label length that has
been set with the Length
function.
• This message appears if you
try to print a label that is
longer than the specified
block length.
• This message appears if the
value entered while setting
the Margin, Length, and
Block Length function is not
within the allowable range.
• This message appears if the
specified characters cannot
be found in the database.
• This message appears if the
values for the blocks,
records or fields to be
printed is not within the
allowable range.
Solution
• Store a text file before trying
to recall or delete one.
• Press n to reduce.
Press b to set the same
or the more numbers of the
blocks.
• Try searching for different
text or a different record
number.
• Change the tape cassette
back again.
• Reduce the size of the
characters, install a tape
with a greater width, or
select the AUTO text size
setting.
A
• Press , and then select a
longer label length.
• Select a longer block length.
• Type in a value that is within
the allowable range.