Teka DW6 42 FI Manual De Uso página 20

Delayed start programming
You can delay the start of a programme in increments of 1 hour up to 24 hours.
Switch dishwasher ON.
Press programme button " B " to choose the desired programme.
Immediately press the Delayed Start button " G ", the delayed start indicator lights, the delayed start
time indicator " F " changes to "
Press the Delayed Start button " G " as many times as necessary until the numerical display shows
the required delay.
To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator
goes out.
Close the door, the delayed start indicator " G " blinks , the time-remaining indicator " F " will blink and
decrease, the programme will start until the delayed start indicator " G " goes out .
1/2 Load Button
This button "H" (see" Close-up View (Control Panel) ) makes it possible to wash dishes using only the
upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy
consumption.
To select 1/2 load:
Select the programme ( see the paragraph entitled" Switching the dishwaher ON")
Press the 1/2 load button " H " , 1/2 load indicator lights.
If the door is closed, the programme starts automatically.
To cancel the 1/2 load
Press programme button " B " and hold it in for about 3 seconds.
- Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.
18
".
B
A
while underway
I
H
F G
en