Flotec FP 7K Manual De Uso página 8

GB
Technical Data
Mains voltage / frequency
Absorbed power
Type of protection / Insulation class
Suction fitting
Maximum flow rate
Maximum head
Maximum depth of immersion
Power cable
Weight
Maximum dimension of pumped solid particles
Maximum temperature of the pumped fluid
Maximum number of starts per hour, uniformly distributed
Minimum priming level (A)*
Minimum suction level (B)*
Connection level (C)*
Stop level (D)*
Technical Data
Mains voltage / frequency
Absorbed power
Type of protection / Insulation class
Suction fitting
Maximum flow rate
Maximum head
Maximum depth of immersion
Power cable
Weight
Maximum dimension of pumped solid particles
Maximum temperature of the pumped fluid
Maximum number of starts per hour, uniformly distributed
Minimum priming level (A)*
Minimum suction level (B)*
Connection level (C)*
Stop level (D)*
Sound pressure level (Lpa) equal to or less than 70 dB(A)
Sound emission values obtained in conformity with the EN 12639 standard
(*) These data refer to Fig. 1. Measurements are expressed in millimetres.
The minimum priming level corresponds to a condition in which the delivery mouth is completely submersed.
(See Fig. 1 - Reference A)
The pumps of this series are not suitable for table fountains or aquariums. If these pumps are used in continuous mode for
ponds with fish, it is necessary to check them at regular intervals of 6 months (if the water contains aggressive substances).
It is also advisable to check the maximum dimension of particles recommended for the pump and take the necessary
measures to prevent the fish from being sucked into the pump.
Ch. 3 Installation (see Fig. 1)
DANGER
Electric shock
risk
DANGER
DANGER
Use the handle provided to transport or lift the pump. To use the pump in permanent installations with rigid pipes, to
install a check valve to avoid the fluid being re-circulated once the pump is stopped. The installation of a quick closing
fitting in a convenient position facilitates cleaning and maintenance operations.
6
When installing, please ensure electropump is disconnected from
electrical supply. Pumps in this series are not suitable for use in a
swimming pool and the relevant cleaning and servicing operations.
To prevent possible injuries to people, avoid inserting hands into the mouth of the
pump if this is connected to the mains.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
FP 7K
230 V ~ 50 Hz
250 Watt
IP X8
41,90 mm (1"1/4M)
7.800 l/h
6 m
7 m
10 m H05 RNF
3,8 Kg
6 mm
35° C
30
100 mm
20 mm
330 mm
150 mm
VIP 180/7
230 V ~ 50 Hz
370 Watt
IP X8
41,90 mm (1"1/4M)
10.800 l/h
7 m
7 m
10 m H05 RNF
4,2 Kg
6 mm
35° C
30
100 mm
20 mm
330 mm
150 mm
2
GB
VIP 130/6
230 V ~ 50 Hz
320 Watt
IP X8
41,90 mm (1"1/4M)
7.800 l/h
6 m
7 m
10 m H05 RNF
3,9 Kg
6 mm
35° C
30
100 mm
20 mm
330 mm
150 mm