Audio Connections - Hitachi CMP5000WXE Manual De Usuario

Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a personal
computer with output that has the vertical
synchronization signal layered on top of the horizontal
synchronization signal.
When connecting to INPUT1
INPUT1
OUTPUT
ANALOG RGB (ANALOG RGB)
On-screen setup is necessary after connection.
Please see pages 14 and 15.
When connecting to INPUT2
INPUT2
(ON SYNC) (H/V SYNC)
G B R HD VD
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
computer's synchronization signal.
When the output impedance of the computer's
synchronization signal is below 75 Ω, set this switch to
the 75 Ω position.
On-screen setup is necessary after connection.
Please see pages 14 and 15.
Notes
÷ When making composite SYNC connections, do not connect
anything to the VD jack. If connected, the picture may not be
displayed properly.
÷ On some types of Macintosh
®
composite SYNC are both output. With this type of
component, please connect using the SYNC ON G connection
(see page 10).
75 2.2
Ô
Ω
kΩ
components, SYNC ON G and
Installation and Connections

Audio Connections

Before making connections, be sure to check that the
audio component's power and the unit's main power is
off.
Connecting the speakers
This unit is equipped with speaker output terminals for
connection to the speaker system (not supplied) specially
designed for use with this unit. Refer to the illustrations
below when making connections to the speaker terminals
on this unit.
Note
When making speaker connections, be sure to match the
polarities (+ and –) of the speaker terminals on this unit and the
corresponding terminals on the speakers. If the polarity is
reversed, the sound will be unnatural and lack bass.
Making connections to the audio inputs on this
unit
This unit features two audio inputs and one audio output.
The following chart shows the video inputs and the
corresponding audio input terminals.
Video
Audio input jacks
input
INPUT1
Stereo mini jack
(L/R)
INPUT2
Audio connections for component (computer)
connected to INPUT 1 or INPUT 2
AUDIO
VD
INPUT OUTPUT
(INPUT1/2)
75 2.2
Ô
Ω
kΩ
Audio input to the
AUDIO INPUT terminals
(stereo mini jack) is
possible for a
component connected to either INPUT1 or INPUT2.
Sound is output from both the AUDIO OUTPUT jacks
(stereo mini jack) and the SPEAKER terminals according
to the video input selection.
Twist exposed
wire strands
together.
Push tab to the open
position, and insert the
wire. Then, close tab
firmly to secure the wire
in place.
Sound output
Sound of the selected video
input is output from the
• SPEAKER terminals
• Stereo mini jacks (L/R).
11
En