Electrolux EHG6341FOK Manual De Instrucciones página 32

32 www.electrolux.com
Problem
There is a dark area
on the multiple zone.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
comes on.
and a number come on. There is an error in the
comes on.
Possible cause
It is normal that there is a
dark area on the multiple
zone.
Power management func‐
tion operates.
The cookware is too large
or you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too
small for the zone.
hob.
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating pro‐
tection for the zones oper‐
ate.
Remedy
Refer to "Daily use" chap‐
ter.
Put large cookware on the
rear zones if possible.
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use" chap‐
ter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical infor‐
mation" chapter.
Disconnect the hob from
the electrical supply for
some time. Disconnect the
fuse from the electrical
system of the house. Con‐
nect it again. If comes
on again, speak to an Au‐
thorised Service Centre.
Deactivate the hob. Re‐
move the hot cookware.
After approximately 30
seconds, activate the zone
again. If the cookware was
the problem, the error mes‐
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati‐
ble with the hob.
Refer to "Hints and tips"
chapter.