Identifying Parts And Controls - Sony CPD-G500 Manual De Instrucciones

Identifying parts and controls

See the pages in parentheses for further details.
Front
RESET INPUT
HD15 BNC
RESET INPUT
HD15 BNC
1 RESET (reset) button (page 16) 1
1 1
This button resets the adjustments to the factory settings.
2 2 INPUT (input) switch (page 8) 2 2
This switch selects the HD15 or BNC video input signal.
3 Control button (page 10) 3 3 3
The control button is used to display the menu and make
adjustments to the monitor, including brightness and contrast
adjustments.
4 1 (power) switch and indicator (pages 7, 16, 20) 4
4 4
This button turns the monitor on and off. The power indicator
lights up in green when the monitor is turned on, and either
flashes in green and orange, or lights up in orange when the
monitor is in power saving mode.
5 5 AC IN connector (page 7) 5 5
This connector provides AC power to the monitor.
Rear
MENU
MENU
6 Video input 1 connector (HD15) (y 6
6 6
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
* DDC (Display Data Channel) is a standard of VESA.
7 7 7 7 Video input 2 connector (BNC) (y
forward side
rear side
AC IN
R G
(HD15)
This connector inputs RGB video signals (0.700 Vp-p,
positive) and sync signals.
5 4 3 2 1
10 9 8
15 14 13 12
Signal
Red
Green
(Sync on Green)
Blue
ID (Ground)
DDC Ground*
Red Ground
Green Ground
Blue Ground
DDC + 5V*
Ground
ID (Ground)
Bi-Directional Data (SDA)*
H. Sync
V. Sync
Data Clock (SCL)*
This connector inputs RGB video signals (0.700 Vp-p,
positive) and sync signals.
forward side
rear side
B HD VD
(BNC)
y 1) (page 6)
y y
7 6
11
y 2) (page 6) y y
5
GB