Clatronic BS 1247 Instrucciones De Servicio página 63

Main Filter (in the Dust Container)
If the dust container is approximately 1/3 full with dust particles, or if the suction
power is reduced, please proceed as follows:
05-BS 1247 neu 63
Emptying the Dust Container
In order to facilitate handling, fi rst release the suction
tube from the connection head (see "Initial Operati-
on").
Lift the key to release the dust container and then
remove it.
Carefully pull the fi lter element out by holding both
clamps. Empty the contents of the dust container.
Then re-insert the fi lter element. The marking
the fi lter element is in line with the
dust container (see illustration). Please ensure that
the fi lter element is straight and tightly in position.
Tighten the dust container and the suction tube again
until it clicks into place.
GB
on
marking of the
63
30.08.2005, 15:45:10 Uhr